Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1589 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD REPLACEMENTREMOVAL PROCEDURE

2004 Oldsmobile Bravada AWD

Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Raise the hood (1).
Support the hood at the front and the rear.

Fig 1: Hood Hinge, Hood Link Assembly & Components
Courtesy of GENERAL MOTORS CORP.
Remove the hood ground strap and nut.
Release the harness and the lamp from the hood.

Fig 2: Removing Hood Ground Strap & Nut
Courtesy of GENERAL MOTORS CORP.
Remove the bolt holding the hood hinge to the hook link assembly (7).
Lower and support the hood.

Fig 3: Hood Hinge, Hood Link Assembly & Components
Courtesy of GENERAL MOTORS CORP.
Remove the outboard sections of the cowl vent grille panel.

Fig 4: Removing Outboard Sections Of Cowl Vent Grille Panel
Courtesy of GENERAL MOTORS CORP.
With an assistant, remove the pivot bolt (3).
With an assistant, remove the hood from the vehicle.
Remove the hood hinge from the hood. Refer to Hood Hinge Replacement .

Fig 5: Hood Hinge, Hood Link Assembly & Components
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.