SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1580 (INSTRUMENT PANEL, GAGES, AND CONSOLE)REPAIR INSTRUCTIONSCONSOLE REPLACEMENT (EXCEPT PRO)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear seat audio control to the console, if equipped. Refer to AUDIO CONTROL REPLACEMENT-REAR SEAT .
  2. Install the console in the vehicle.
  3. Connect the wire connectors.
  4. Move the console forward in order to install the retaining screws.
    NOTE: Refer to FASTENER NOTICE .
  5. Install the 2 screws (1).

    Tighten 

    Tighten the screws to 4 N.m (35 lb in).

  6. Install the cupholder to the console. Refer to Cupholder Replacement (Luxury)   or Cupholder Replacement (Non-Luxury)   or Cupholder Replacement (Rear)   or Cupholder Replacement (Pro)   . 
  7. Install the upper console bezel. Refer to Bezel Replacement - Floor Console (Non-Luxury Upper)   or Bezel Replacement - Floor Console (Luxury Upper)   or Bezel Replacement - Floor Console (Non-Lux Lower)   . 
  8. Install both front seats. Refer to SEAT REPLACEMENT-FRONT BUCKET .
    9. Fig 1: Console (Except Pro)
    G01579483Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.