SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1550 (STEERING WHEEL AND STEERING COLUMN)REPAIR INSTRUCTIONSLINEAR SHIFT ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the linear shift assembly onto the steering column support assembly.
    NOTE: Refer to FASTENER NOTICE .
  2. Secure the linear shift assembly to the steering column assembly with the 3 flat head tapping screws.

    Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.

    Tighten 

    Tighten the 3 TORX® screws to 10 N.m (89 lb In).

    Fig 1: Install Linear Shift Assembly Onto Steering Column Support Assembly
    G01479772Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic transmission shift lock control.
  4. Install the shift lever clevis and put the column in the neutral position.
  5. The neutral position is 2 positions from the park position.
    Fig 2: Install Automatic Transmission Shift Lock Control
    G01479773Courtesy of GENERAL MOTORS CORP.
  6. Slide the park position switch assembly onto the linear shift assembly.
  7. Connect the automatic transmission shift lock control connector onto the park position switch assembly.
    Fig 3: Install Park Position Switch Assembly
    G01479774Courtesy of GENERAL MOTORS CORP.
  8. Connect the park lock cable assembly (1) to the lock module assembly in the following way:
    1. 8.1. Place the steering column lock cylinder set into the off position.
    2. 8.2. Place the shift lever clevis into the park position.
    3. 8.3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly.
  9. Install the shift lever. Refer to SHIFT LEVER REPLACEMENT (WITH TOW/HAUL SWITCH)   or SHIFT LEVER REPLACEMENT (WITHOUT TOW/HAUL SWITCH)   .  .
  10. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  11. Enable the SIR system. Refer to ZONE 3 .
    Fig 4: Connect Park Lock Cable Assembly
    G01479775Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.