Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions For Setting DTC
DTC B0077 will set when SDM does not receive a valid identification message within 5 seconds of EFS being powered up, status message is not retrieved or SDM has reset EFS twice without detecting valid identification message.
DTC B0079 will set when SDM receives an identification message from EFS that does not match identification stored in memory or after SDM has tried twice to reset EFS without detecting correct identification message. DTC B0080 will set when SDM has received a Not Okay (NOK) message from EFS.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.