Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Activating System
2004 Oldsmobile Bravada AWDSECTION Activating System
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition is off and key is removed. Connect driver side impact air bag module connector, located under driver seat. Install Connector Position Assurance (CPA) clip. See Figure. Connect passenger-side air bag module Yellow connector. Install CPA clip. See Figure. Install passenger-side instrument panel end cap.
- Connect driver-side air bag module Yellow connector. Install CPA clip. See Figure. Install SRS fuse in fuse block, located in left side of instrument panel. See Figure. Install driver-side instrument panel end cap. Check system for proper operation. See SYSTEM OPERATION CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.