Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the IP dimmer/HUD switch to the IP cluster bezel.
- Install the IP dimmer/HUD switch retaining screws.
Tighten: Tighten the IP dimmer/HUD switch retaining screws to 1.5 N.m (13 lb in).
- Install the bezel to the IPC.
Align the bezel onto the guide pins.
- Install the IP cluster bezel retaining screws.
Tighten: Tighten the instrument panel cluster bezel retaining screws to 1.5 N.m (13 lb in).
- Connect the IP dimmer/HUD switch electrical connector.
- Connect the DIC switch electrical connector.
- Install the IPC to the vehicle. Refer to Instrument Panel Cluster (IPC) Replacement .
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.