Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Transfer the HUD-to-steering column bracket retaining screw and nut, to the replacement HUD, if necessary.
- Install the head-up display (HUD) to the vehicle:
- Install the HUD onto the dash panel mounting studs.
- Slide the HUD retaining screw into the slot on the steering column bracket.
- Install the HUD retaining nuts.
Tighten: Tighten the HUD retaining nuts to 5 N.m (44 lb in).
- Tighten the HUD-to-steering column bracket retaining screw.
Tighten: Tighten the HUD-to-steering column bracket retaining screw to 3 N.m (27 lb in).
- Position the IPC to the steering column bracket.
- Check that the IPC retaining tab (1) is positioned correctly to the steering column bracket (2).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.