Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1456 (STEERING WHEEL AND STEERING COLUMN)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada AWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Actuator Retaining Screws | 9 N.m | 80 lb in |
| Column Support Bracket Nuts Lower (Tighten in Sequence) | 24 N.m | 18 lb ft |
| Column Support Bracket Nuts Upper (Tighten in Sequence) | 24 N.m | 18 lb ft |
| Intermediate Shaft to the Steering Column Pinch Bolt | 48 N.m | 35 lb ft |
| Intermediate Shaft to the Steering Gear Pinch Bolt | 34 N.m | 25 lb ft |
| Intermediate Shaft to the Steering Gear Pinch Bolt Shield Screw | 3.5 N.m | 31 lb in |
| Steering Column Support Screws | 17 N.m | 13 lb ft |
| Steering Column Trim Cover Screws Lower | 4 N.m | 35 lb in |
| Steering Column Trim Cover Screws Upper | 1.5 N.m | 13 lb in |
| Steering Wheel Nut | 41 N.m | 30 lb ft |
| Telescope Drive Bolt | 7 N.m | 62 lb in |
| Telescope Drive Bracket Screw | 7 N.m | 62 lb in |
| Turn Signal Multifunction Switch Screws | 7 N.m | 62 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.