Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 145 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Torque Specifications
2004 Oldsmobile Bravada AWDSECTION Torque Specifications
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Front seat mounting nuts | 41 (56) | |
| Steering wheel nut | 29 (39) | |
| INCH Lbs. (N.m) | ||
| Front end discriminating sensor bolt | 89 (10.0) | |
| Instrument Panel Cluster (IPC) screws | 18 (2.0) | |
| Instrument panel upper trim pad screws | 18 (2.0) | |
| Passenger-side air bag module bolts | 89 (10.0) | |
| Sensing & Diagnostic Module (SDM) fasteners | 89 (10.0) | |
| Side impact air bag module bolts | 89 (10.0) | |
| Side Impact Sensor (SIS) bolts | 89 (10.0) | |
| Steering column cover | ||
| Upper screw | 15 (1.7) | |
| Lower screws | 25 (2.8) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.