Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation (2.2L)
2004 Oldsmobile Bravada AWDSECTION Removal & Installation (2.2L)
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Turn OFF the ignition. Disconnect Intake Air Temperature (IAT) sensor harness connector. The IAT sensor is mounted in the air intake duct. Loosen clamp at air cleaner assembly. Remove push-pin attachment from outlet resonator/duct assembly-to-support bracket.
- Loosen clamp at throttle body assembly. Disconnect PCV fresh air hose at cam cover. Remove outlet resonator/duct assembly. Disconnect the EI module harness connector. See Figure . Remove attachment screws from the EI module. Remove the EI module. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.