Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 144 (ENGINE CONTROLS - REMOVAL, OVERHAUL & INSTALLATION)FUEL SYSTEMSTHROTTLE BODYINSTALLATION
2004 Oldsmobile Bravada AWD
Throttle Body: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Remove shop towel from throttle body opening. Install throttle body gasket. Install throttle body and bolts. Tighten throttle body bolts to specification. See TORQUE SPECIFICATIONS .
- Connect throttle body electrical connector. Position outlet resonator/duct assembly into position. Connect PCV fresh air vent hose assembly. Position outlet resonator/duct assembly up with support bracket and install push-pin. Tighten clamp at air cleaner assembly. Turn ON ignition for one minute while the engine control module automatically relearns the throttle position.
- Remove shop towel from throttle body opening. Install throttle body gasket. Install throttle body and bolts. Tighten throttle body bolts to specification. See TORQUE SPECIFICATIONS .
- Connect coolant hoses to throttle body and unclamp hoses. Connect PCV fresh air and vacuum hoses. Connect throttle body electrical connector. Position outlet resonator/duct assembly into place. Tighten clamp at throttle body assembly. Position outlet resonator/duct assembly to support bracket and install bolts. Tighten bolts to specification.
- Tighten clamp at air cleaner assembly. Connect negative battery cable. Tighten negative battery terminal bolt to specification. If the throttle body assembly has been replaced, an automatic relearn procedure must be completed by the engine control module. Do not depress the accelerator pedal assembly during this procedure. To complete the relearn procedure, turn ignition to RUN position for one minute.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.