SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1414 (ENGINE CONTROL SYSTEM - 4.8L, 5.3L, & 6.0L - INTRODUCTION)REPAIR INSTRUCTIONSAIR CLEANER ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD

Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Air Cleaner Assembly
    GM1217755Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner cover (2), the filter element (6), the mass air flow (MAF)/intake air temperature (IAT) sensor (3), and the air inlet duct (5) from the lower air cleaner housing/washer solvent tank assembly (4). Refer to Air Cleaner Element Replacement .
    2. Fig 2: Locating Electrical Connectors
    GM907812Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the following electrical connectors:
    • Windshield washer pump (1)
    • Headlamp washer pump (2), if equipped
    • Low solvent level sensor (4)
    • Lift gate washer pump (6), if equipped
  3. Remove the washer solvent level sensor wire harness from the wire harness retaining clips (3, 5).
    4. Fig 3: Disconnecting/Connecting Headlamp Washer Hose
    GM1362808Courtesy of GENERAL MOTORS CORP.
  4. If applicable, disconnect the headlamp washer hose from the headlamp washer pump located on the lower air cleaner housing/washer solvent tank. Cap the headlamp washer pump outlet fitting to prevent loss of washer solvent.
    5. Fig 4: Removing/Installing Lower Air Filter Housing/Washer Solvent Tank Assembly
    GM1361746Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the washer pump hoses (3) and plug the washer pump outlet ports to prevent loss of washer solvent.
  6. Remove the 2 air cleaner housing/washer solvent tank assembly retaining nuts (1) from the mounting studs.
  7. Lift the lower air filter housing/washer solvent tank assembly (2) off of the studs and remove the assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.