SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1410 (FRAME & UNDERBODY)REPAIR INSTRUCTIONSTRANSMISSION SUPPORT REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Crossmember
    GM702036Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission support to the frame. (15 series)
    2. Fig 2: Identifying Crossmember & Bolts
    GM652595Courtesy of GENERAL MOTORS CORP.
  2. Install the transmission support to the frame. (25/35 series)
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the bolts and the nuts in order to retain the transmission support to the frame.

    Tighten:  Tighten the nuts to 95 N.m (70 lb ft).

  4. Lower the rear of the transmission.
    5. Fig 3: Identifying Transmission Mount Nuts
    GM647997Courtesy of GENERAL MOTORS CORP.
  5. Install the transmission mount to the transmission support.
  6. Install the nuts in order to retain the transmission mount to the transmission support.

    Tighten:  Tighten the nuts to 40 N.m (30 lb ft).

  7. Remove the transmission jack.
  8. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.