Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brackets to the vehicle.
- Install the bolts that secure the brackets to the vehicle.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).
- Install the running board assembly to the vehicle.
- Install the bolts that secure the running boards to the brackets.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).
- Install the bolts retaining the HVAC pipes in order to facilitate the installation of the assist step brackets. Refer to HEATER PIPE
.
Tighten: Tighten the bracket bolts to 25 N.m (18 lb ft).
- Install the bolts that secure the end caps to the vehicle.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).
NOTE:
Refer to FASTENER NOTICE
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.