SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1357 (BODY REAR END)REPAIR INSTRUCTIONSLIFTGATE REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Hinge And Bolts
    GM876238Courtesy of GENERAL MOTORS CORP.
  1. Position the lift gate hinges to the marked location points on the lift gate, with an assistant.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts (1) to the lift gate hinges (2), with an assistant.

    Tighten:  Tighten the lift gate hinge bolts to 19.5 N.m (14 lb ft).

  3. Support the lift gate.
  4. Install the lift gate struts. Refer to Strut Replacement - Liftgate  .
    5. Fig 2: Rear Wiper Relay Components
    GM876255Courtesy of GENERAL MOTORS CORP.
  5. Install the rear wiper relay (1) with bracket (4), secure relay with screws (3).
  6. Install the lift gate harness. Refer to Wiring Harness Replacement - Liftgate  .
  7. Install the high mount stop lamp. Refer to High Mounted Stop Lamp Replacement .
  8. Install the lift gate window latch. Refer to Latch Replacement - Liftgate Window  .
  9. Install the lift gate latch. Refer to Latch Replacement - Liftgate  .
  10. Install the license lamps. Refer to License Lamp Replacement .
  11. Install the lift gate applique. Refer to Liftgate Applique Replacement  .
  12. Install the lift gate window weather-strip. Refer to Liftgate Applique Replacement  .
  13. Install the lift gate window. Refer to Window Replacement - Liftgate  .
  14. Install the lift gate window struts. Refer to Strut Replacement - Liftgate Window  .
  15. Install the wiper motor assembly. Refer to Wiper Motor Replacement - Liftgate .
  16. Install the roof and mid spoilers, if removed. Refer to Spoiler Replacement - Rear (Roof)  or Spoiler Replacement - Rear (Mid)  in Body Rear End.
  17. Install the lift gate trim panel. Refer to Trim Panel Replacement - Liftgate  .
  18. Close lift gate.
  19. Install the rear wiper arm. Refer to Wiper Arm Replacement - Rear .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.