Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1357 (BODY REAR END)REPAIR INSTRUCTIONSLATCH REPLACEMENT - LIFTGATE WINDOWINSTALLATION PROCEDURE

2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Window Latch Bolts

Courtesy of GENERAL MOTORS CORP.

Connect the rod to the lift gate window latch.
Install the lift gate window latch (1) to the lift gate (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts (2) to the lift gate window latch (1).
Tighten: Tighten the lift gate window latch bolts (2) to 7.0 N.m (62 lb in).
Install the rear lift gate window connector (4) to the lift gate (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts (3) to the lift gate window connector (4).
Tighten: Tighten the lift gate window connector bolts (3) to 7.0 N.m (62 lb in).
Close the lift gate window.

Fig 2: Liftgate Window Latch Components

Courtesy of GENERAL MOTORS CORP.

Open the lift gate.
Install the lift gate window latch electrical connector retainer (3) to the lift gate (4).
Connect the lift gate window latch electrical connector (2) to the lift gate harness (1).
Install the lift gate trim panel. Refer to Trim Panel Replacement - Liftgate .
Close the lift gate.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.