Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1357 (BODY REAR END)REPAIR INSTRUCTIONSHANDLE REPLACEMENT - LIFTGATEINSTALLATION PROCEDURE

2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Handle Components

Courtesy of GENERAL MOTORS CORP.

Install the liftgate handle (2) to the liftgate applique studs (3).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 nuts (1) to the liftgate handle (2).
Tighten: Tighten the liftgate handle nuts to 4.0 N.m (35 lb in).
Connect the cable to liftgate handle.
Install liftgate trim panel. Refer to Trim Panel Replacement - Liftgate .
Close the liftgate.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.