Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1300 (HVAC SYSTEMS - MANUAL)REPAIR INSTRUCTIONSMODE CONTROL CABLE REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD
Removal Procedure
2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the radio. Refer to RADIO REPLACEMENT in Entertainment.
- Remove the center knob from the HVAC control unit.
- Remove the screw from the control unit.
- Remove the center console and heater control trim panel (1).
Important: Note the routing of the cable to make installation easier.
- Disconnect the mode control cable from the HVAC control unit.
- Disconnect the mode control cable from the HVAC module assembly.
- Remove the mode control cable from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.