Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the following to the HVAC control unit:
- The lamp bulbs.
- The electrical connector
- The temperature control cable
- The mode control cable
- Install the HVAC control unit to the instrument panel.
- Install the center console and heater control trim panel (1). Secure the panel with the screw.
- Install the center knob to the HVAC control unit.
- Adjust the cables as necessary, refer to the following:
- TEMPERATURE CONTROL CABLE ADJUSTMENT
- MODE LINKAGE ADJUSTMENT in Heating, Ventilation and Air Conditioning
- Install the radio. Refer to RADIO REPLACEMENT in Entertainment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.