SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 130 (COMPUTER RELEARN PROCEDURES)FORD MOTOR CO.POWER SLIDING DOOR INITIALIZATION (WINDSTAR ONLY)
2004 Oldsmobile Bravada AWD

Power Sliding Door Initialization (WINDSTAR Only)

2004 Oldsmobile Bravada AWDSECTION Power Sliding Door Initialization (WINDSTAR Only)
WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If overhead console on/off switch is in OFF position, PSD will not operate from "B" pillar switch and power assist operation will be disabled.

Disconnecting battery, removing Fuse Junction Box (FJB) fuse No. 6 (15-amp), disconnecting modules or removing power supply from some modules could cause PSD module to lose memory. PSD initialization procedure must be performed before PSD will operate under all conditions. Power sliding door initialization procedure is a learning process for modules to identify PSD full open position and PSD full close position. After power is restored to vehicle, initialize PSD(s) with following procedure:

  1. Ensure both PSDs are fully closed, latched and unlocked. Ensure vehicle is in Park and fuel filler door is closed. Switch overhead console on/off switch to ON position.
    2. NOTE: When overhead console on/off switch is in ON position, remote keyless entry transmitter or "B" pillar open/close switches may be used in place of overhead console open/close switch to initialize power assist operation for Power Sliding Doors (PSD).
  2. Press driver's and passenger's overhead console open/close switch to open driver-side and passenger-side PSD. After PSD is fully open and stopped, press driver-side and passenger-side overhead console open/close switches to close both PSDs.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.