Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (STEERING WHEEL AND STEERING COLUMN)ADJUSTMENTSIGNITION SWITCH
2004 Oldsmobile Bravada AWD
Ignition Switch
2004 Oldsmobile Bravada AWDSECTION Ignition Switch
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
New ignition switch is pinned in OFF-LOCK position. Plastic pin must be removed before operating switch.
- Set key lock cylinder in OFF-LOCK position. On fixed column, set ignition switch slider (where actuator rod connects to switch) to OFF-LOCK position by moving slider as far left as possible, and then one detent to right. See Fig 1.
- On tilt column, set ignition switch slider (where actuator rod connects to switch) to OFF-LOCK position by moving slider to right as far as possible, and then one detent to left. See Fig 1.
- Install switch. Tighten switch screws to 35 INCH lbs. (4 N.m). Ensure ignition switch functions properly with lock cylinder in all positions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.