Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hood latch support to the upper and lower tie bar.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the to the hood latch support to upper tie bar bolts.

    Tighten 

    Tighten the hood latch support upper tie bar bolts to 25 N.m (18 lb ft).

  3. Install the hood latch support to lower tie bar nut.

    Tighten 

    Tighten the hood latch support to lower tie bar nut to 10 N.m (89 lb in).

  4. Install the hood latch to the hood latch support Refer to Hood Latch Replacement .
    Fig 1: Hood Latch Support
    G01616888Courtesy of GENERAL MOTORS CORP.
  5. Install the front bumper fascia upper support to the hood latch support. Refer to FASCIA SUPPORT REPLACEMENT -- FRONT BUMPER UPPER .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.