SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 129 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL PUMPINSTALLATION
2004 Oldsmobile Bravada AWD

Fuel Pump: Installation

2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Fuel pump strainer must be in a horizontal position when installing fuel tank sending unit into fuel tank. Ensure fuel pump strainer does not block the travel of the fuel sensing unit float arm.

Clean fuel sending unit sealing area. Install NEW fuel sending unit "O" ring onto the fuel tank opening. Lower fuel tank sending unit into fuel tank. Install fuel sending unit assembly retaining ring using Retaining Ring Remover/Installer (J-44402). Reinstall fuel tank. See FUEL TANK . Check for fuel leaks.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.