Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Lower Control Arm Bushings Replacement (Vertical): Notes
2004 Oldsmobile Bravada AWDSECTION Notes
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- J 21474 Control Arm Bushing Installer
- J 21474-01 Control Arm Bushing Set
- J 21474-2 Bushing Installer
- J 21474-4 Nut
- J 21474-5 Control Arm Bushing Receiver
- J 21474-13 Control Arm Bushing Installer
- J 21474-27 Puller Bolt Thrust Bearing
- J 23444-A Extreme Press Lubricant- 1/4-Ounce Tube
- J 34126 Driven Sprocket Support Bearing Installer
- J 35379 Front Knuckle Support
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.