Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1286 (BODY REAR END)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada AWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Body Rear End Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Fuel Filler Pocket Screws | 2 N.m | 18 lb in |
| Fuel Filler Pocket to Fuel Filler Neck Bolts | 5 N.m | 44 lb in |
| Fuel Filler Pocket to Quarter Panel Screw | 2 N.m | 18 lb in |
| Interface Module Bracket Nuts | 4 N.m | 35 lb in |
| Lock Actuator Bolts | 3 N.m | 26 lb in |
| Rear Compartment Hinge to Rear Quarter Bolts | 25 N.m | 18 lb ft |
| Rear Compartment Lid Ajar Switch Screw | 5 N.m | 44 lb in |
| Rear Compartment Lid Hinge Nuts | 25 N.m | 18 lb ft |
| Rear Compartment Lid Latch Bolts | 10 N.m | 89 lb in |
| Rear Compartment Lid Lock Striker Bolts | 16 N.m | 12 lb ft |
| Rear Compartment Lid Spoiler Nuts | 6 N.m | 53 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.