Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the front fender liner to the wheelhouse opening over the stud.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the nut to the stud at the rear of the front fender liner.
Tighten
Tighten the front fender liner nut to 3 N.m (27 Ib in).
- Install the screws to the front fender liner at the rear of the fender.
Tighten
Tighten the front fender liner screws to 7 N.m (61 Ib in).
- Install the screws to the front tab of the front fender liner at the lower engine compartment side rail.
Tighten
Tighten the front fender liner screws to 7 N.m (61 Ib in).
- Install the screws to the front fender liner at the front bumper fascia.
Tighten
Tighten the front fender liner to front bumper fascia screws to 2 N.m (18 Ib in).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.