Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Central Sequential Fuel Injection (CSFI) Assembly
CSFI assembly is a non-repairable injector unit consisting of a fuel meter body, fuel pressure regulator, fuel injector and poppet nozzles with fuel tubes. CSFI assembly is housed in the lower manifold assembly. Fuel pump and pressure regulator maintain fuel pressure at 60-66 psi (413.7-455.1 kPa) under all operating conditions.
When injector is energized, pressurized fuel passes down fuel distribution tubes to poppet nozzles located at rear of intake valves. Fuel pressure forces poppet valves open, spraying fuel into cylinders when intake valves are open. As fuel pressure drops (due to all poppets opening or injector de-energizing), poppet nozzle spring pressure closes poppet nozzle until pressure again builds high enough to overcome poppet nozzle spring pressure. Excess fuel is returned to the fuel tank via the fuel return line.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.