Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Knock Sensor
The Knock Sensor (KS) is a piezoelectric device which detects abnormal engine vibrations (spark knock) in the engine. This vibration results in the production of a very low AC signal, which is sent from the KS to the KS module (integral to PCM). The PCM then retards ignition timing until the engine knock ceases. Two KS are used on some models.
A fault in the KS circuit may set a DTC. See appropriate SELF-DIAGNOSTICS article. When a related DTC is not present and the KS system is the suspected cause of a driveability problem, perform functional check of KS system. See appropriate SYSTEM & COMPONENT TESTING article.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.