Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the anchor plate through the slit in the carpet.
- Align the anchor plate with the raised end forward.
- Start the bolt through the anchor plate into the hole in the floor reinforcement.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Important: Insure the anchor plate does not turn while tightening the bolt.
- Tighten the child restraint tether anchor plate bolt.
Tighten
Tighten the child restraint tether anchor plate bolt to 27 N.m (20 lb ft).
- Reposition the carpet over the bolt.
- Install the child restraint tether, if the child restraint is installed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.