Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
2004 Oldsmobile Bravada AWDSECTION Removal & Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue and 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Remove fuel sender assembly from fuel tank. See FUEL PUMP . Disconnect the fuel pump electrical connector.
- Remove the fuel level sensor electrical connector retaining clip. Disconnect the fuel level sensor electrical connector from under the fuel sender cover. Remove the fuel level sensor retaining clip. Squeeze the locking tangs and remove the fuel level sensor. See Fig 1.
- Remove the fuel pump and fuel level sensor electrical retaining clip at the top of the fuel sender assembly. Disconnect the fuel pump and fuel level sensor electrical connector. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.