Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Replacement: Notes
2004 Oldsmobile Bravada AWDSECTION Notes
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- J 25034-C Power Steering Pump Pulley Remover
- J 42188 Ball Joint Separator
- J 39580 Engine Support Table
- J 39580-500 Engine Support Table Top
- J 41798 Engine Lifting Brackets
- J 42203 Driveline Support
- J 36221 Hydraulic Clutch Line Separator
- J 25033-C Power Steering Pump Pulley Installer
- J 36660-A Torque Angle Meter
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.