Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Throttle Body Relearn Procedure
- Turn ignition off for 10 seconds.
- Turn ignition on, engine off.
- Ensure these engine operating parameters are met before proceeding:
- ECT is 41-212°F (5-100°C).
- IAT is more than 41°F (5°C).
- Battery voltage is more than 10 volts.
- Accelerator pedal angle is less than 14 degrees.
- Leave ignition on for one minute with engine off.
The ECM will start at 29 seconds to cycle the throttle plate from rest position to full closed, then from the full closed position to around 14 percent. This will take about 3 seconds. The ECM will then return the throttle to the rest position. During this throttle plate cycle, the ECM will have learned the lower and rest position TP sensor values, actuator motor torque to overcome spring pressure as well as both spring return rates.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.