Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1198 (STEERING WHEEL AND STEERING COLUMN)SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Section 1198 (Steering Wheel And Steering Column): Specifications
2004 Oldsmobile Bravada AWDSECTION Specifications
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Intermediate Shaft to the Steering Gear Pinch Bolt | 34 N.m | 25 lb ft |
| Steering Column Trim Cover Screws Lower | 4 N.m | 35 lb in |
| Column Support Bracket Nuts Upper (Tighten in Sequence) | 24 N.m | 17 lb ft |
| Column Support Bracket Nuts Lower (Tighten in Sequence) | 24 N.m | 17 lb ft |
| Lower Steering Coupling Shield Screw | 3.5 N.m | 31 lb in |
| Multifunction Switch Screws | 7 N.m | 62 lb in |
| Steering Column Support Screws | 17 N.m | 13 lb ft |
| Steering Wheel Set Nut | 41 N.m | 30 lb ft |
| Intermediate Shaft to the Steering Column Pinch Bolt | 48 N.m | 35 lb ft |
| Steering Column Trim Cover Screws Upper | 1.4 N.m | 12 lb in |
| Actuator Retaining Screws | 9 N.m | 80 lb in |
| Telescope Drive Bolt | 7 N.m | 62 lb in |
| Telescope Drive Bracket Screw | 7 N.m | 62 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.