Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Parameters
2004 Oldsmobile Bravada AWDSECTION DTC Parameters
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Engine run time more than 60 seconds.
- Engine speed between 600-6200 RPM.
- RPM change less than 50 RPM.
- Throttle angle change is less than 2 percent.
- TCC change less than 1.3 percent (A/T).
- IAC change less than 5 counts.
- No CMP, CKP, ECT, EVAP leak, fuel injector, fuel tank pressure, fuel trim, idle speed, MAP, misfire, HO2S1, TP, P0446, P0502, or P1441 DTCs are set.
DTC sets when MAP sensor voltage is out of range for more than 12 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.