Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the automatic level control height sensor link onto the height sensor arm.
- Install the automatic level control height sensor with the bracket onto the vehicle.NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the automatic level control height sensor bracket bolts (1).
Tighten: Tighten the height sensor bracket bolts to 85 N.m (63 lb ft).
- Install the automatic level control sensor link to the lower control arm ball stud.
- Install the automatic level control sensor electrical connector (1).
- Lower the vehicle.
- Perform a diagnostic system check. Refer to Diagnostic System Check - Automatic Level Control (With Inflator) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.