SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1149 (SUSPENSION CONTROL SYSTEM - SUSPENSION LEVELING)REPAIR INSTRUCTIONSAIR LINE TUBING REPAIR
2004 Oldsmobile Bravada AWD

Air Line Tubing Repair

2004 Oldsmobile Bravada AWDSECTION Air Line Tubing Repair
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate the leaking area with soap and water or a stethoscope.
    2. Fig 1: Cross Section Of Air Line Tubing
    GM187172Courtesy of GENERAL MOTORS CORP.
  2. Cut and remove the leaking line (2) section.
  3. Remove the plastic retainer pin from one of the nuts.
  4. Slide the air line tube onto the nut until the line bottoms in the rubber seal (5).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Hold the air line tube in position.

    Tighten:  Tighten the air line tube repair nut to 8 N.m (70 lb in).

  6. Install the air line tube to the other end of the coupling.
  7. Repeat Steps 3 through 5.
    8. IMPORTANT: Ensure that the repaired air line tube is secured in a location where the line is not pinched, or kinked, and will not contact the exhaust system.
  8. Install the air line tube to the vehicle.
  9. Inflate the automatic level control system and inspect for leaks.
  10. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.