Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the coil spring (2).
- Use the utility jack in order to raise the lower control arm and load the suspension.
- Use the J 41820 in order to connect the ball joint to the knuckle.
- Install the stabilizer link to the lower control arm.
- Use the utility jack in order to support the lower control arm.
- Install the ABS electrical connector mounting bracket.
- Connect the ABS electrical connector.
- Install the brake caliper mounting bracket.
- Install the parking brake cable mounting bracket.
- Install the brake calipers. Refer to Brake Caliper Replacement - Rear in Disc Brakes.
- Install the wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.