Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions For Clearing MIL/DTC
2004 Oldsmobile Bravada AWDSECTION Conditions For Clearing MIL/DTC
WARNING: This page is about a different car, the 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- The Last Test Failed status will clear when the DTC runs and passes.
- The AF ECM will turn OFF the MIL after 3 consecutive drive trips that the DTC runs and passes.
- The History status will clear after 40 consecutive WARM-UP cycles with NO failures of ANY DTC.
- All DTC Information can be cleared with a scan tool.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.