Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Alignment Checking
Insert a 19 mm (0.750 in) diameter guide pin or drill bit into the frame-to-body guide pin hole in order to inspect the frame-to-body alignment. If the guide pins will not fit, the frame is not in correct alignment with the body. To realign the frame refer to Frame Replacement - Front (W/AWD) or Frame Replacement - Front (W/FWD) and Crossmember Replacement .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.