SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1135 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER ARM REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD

Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wiper Arm Components
    GM512035Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition switch to the ACCY position.
  2. Turn the wiper switch to the DELAY position.
  3. Turn the ignition OFF when the wiper arms are in the innerwipe position and not moving.
  4. Disconnect the washer hose from the washer nozzle.
  5. Remove the cover from the wiper arm nut.
  6. Remove the wiper arm nut from the wiper transmission drive shaft.
  7. Using J 39822  , remove the wiper arm from the wiper transmission drive shaft. See Special Tools and Equipment .
  8. Remove the wiper blade from the wiper arm. Refer to Wiper Arm Blade Replacement .
  9. Clean the knurls of the wiper transmission drive shaft with a wire brush.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.