SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1127 (REAR PARKING ASSIST SYSTEM)REPAIR INSTRUCTIONSOBJECT ALARM MODULE REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear object alarm detection module.
    Fig 1: View Of Rear Object Alarm Detection Module
    GM785378Courtesy of GENERAL MOTORS CORP.
  2. Install the electrical connector to the module.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts that secure the rear object alarm detection module.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Secure the top of the quarter trim over the bolts.
  5. Install the cargo tie-down loops from the rear quarter trim.
  6. Install the rear liftgate sill.
    Fig 2: Identifying Rear Liftgate Sill
    GM786746Courtesy of GENERAL MOTORS CORP.
  7. Install the storage compartment. Refer to Storage Compartment Replacement - Rear (Rendezvous) in Interior Trim.
  8. Install the upper trim from the second and third row pillars.
    Fig 3: View Of Upper Trim From Second & Third Row Pillars
    GM786752Courtesy of GENERAL MOTORS CORP.
  9. Install the guide loop bolts from the second and from the third row seat belts.
    Fig 4: Locating Guide Loop Bolt
    GM786753Courtesy of GENERAL MOTORS CORP.
  10. Close the guide loop covers to the left rear seat belt.
    Fig 5: Identifying Guide Loop Covers From LH Rear Seat Belt
    GM786759Courtesy of GENERAL MOTORS CORP.
  11. Return the second and the third row seats to their upright positions.
    Fig 6: Aligning Second Row Seats Forward
    GM786757Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.