Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test Description
2004 Oldsmobile Bravada AWDSECTION Test Description
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: Verify that the DTC is current or history by monitoring the switch status for which the code is set.
- 3: Tests the memory select switch for an internal fault.
DTC B2755 or B2760
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Driver Seat Schematics Connector End View Reference: Power Seat Systems Connector End Views |
|||
| 1 | Did you perform the Power Seat System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Power Seat Systems |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 5 | Go to Step 4 |
| 4 | Test the switch signal circuit for a short to ground. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 6 |
| 5 | Inspect and repair any damage to the memory select switch connector and terminals which may cause the condition. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 7 |
| 6 | Inspect and repair any damage to the memory seat module connector and terminals which may cause the condition. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 7 | Replace the memory select switch. Refer to Memory Seat Switch Replacement (Rendezvous) . Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the memory seat module. Refer to Memory Seat Control Module Replacement . Did you complete the replacement? |
Go to Step 9 | - |
| 9 |
|
Go to Step 2 | System OK |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.