Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1122 (BODY REAR END)REPAIR INSTRUCTIONSSTRUT REPLACEMENT - ENDGATEINSTALLATION PROCEDURE

2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Position the assist rods to the endgate.

Fig 1: Assist Rod View
Courtesy of GENERAL MOTORS CORP.
Install the upper end of the assist rods to the ball joint. Press in to place until fully seated.

Fig 2: Locating Upper End Of Assist Rods
Courtesy of GENERAL MOTORS CORP.
Install the lower end of the assist rods to the ball joint. Press in to until fully seated.

Fig 3: Locating Lower End Of Assist Rods

Courtesy of GENERAL MOTORS CORP.

Close the endgate.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.