Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Enabling Procedure
2004 Oldsmobile Bravada AWDSECTION Enabling Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition.
- Connect the vehicle harness yellow connector (2) to the passenger side impact module yellow connector (1).
- Install both CPAs (3) to the passenger side impact module yellow connector (1).
- Install the SIR Fuse.
- Install the console accessory wiring junction block access hole cover.
- Staying well away from all inflator modules and pretensioners, turn ON the ignition.
- The AIR BAG indicator will flash 7 times.
- The AIR BAG Indicator will then turn OFF.
- Perform Diagnostic System Check - SIR if the AIR BAG indicator does not operate as described.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.