Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
The SIR scan tool data definitions contain a brief description of all SIR related parameters available on the scan tool. The parameters that are available on the scan tool are listed below in alphabetical order.
- 8-Digit GM Part Number
-
The scan tool displays an 8-digit part number. This number is the GM part number that is stored within the SDM memory.
- Calibration ID
-
The scan tool displays a 4-digit number. This calibration ID is the check sum of the SDM read only memory contents.
- Component Serial #8-11
-
The scan tool displays digits 8 through 11 of the SDM serial number.
- Component Serial #12
-
The scan tool displays digit 12 of the SDM serial number.
- Driver Belt Status Changed This Ignition Cycle
-
The scan tool displays Yes or No. Driver seat belt has been buckled or unbuckled after the ignition is turned ON.
- Driver Seat Belt A/D
-
The scan tool displays 0 or 12 volts. If driver seat belt is buckled = 12 volts, unbuckled = 0 volts.
- Driver Seat Belt Status
-
The scan tool displays Buckled or Unbuckled. The signal from the drivers seat belt switch indicates whether the driver seat is buckled or unbuckled.
- Driver Side Impact Sensor ID
-
The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the Driver SIS.
- Electronic Front End Sensor ID
-
The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the EFS (also known as Front Discriminating Sensor).
- Ignition Voltage
-
The scan tool displays 0-20 volts. The Ignition represents the system voltage measured by the SDM at its ignition feed.
- Julian Date of Build
-
This displays the day of the year the module was built.
- Passenger Side Impact Sensor ID
-
The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the Passenger SIS.
- PROM ID
-
The scan tool displays a 4-digit number. This number is the programmable read-only memory (PROM) ID.
- VIN Information
-
The scan tool displays a list. The Powertrain Control Module (PCM) is programmed in the assembly plant with the last four digits of SDM part number and the VIN of the vehicle.
- Year Module Built
-
The scan tool displays what year the module was built.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.