Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Output Controls
2004 Oldsmobile Bravada AWDSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| GEN L-Terminal | Engine Output Controls/GEN L-Terminal | The powertrain control module (PCM) commands the generator OFF by removing the 5-volt reference signal from the L terminal of the voltage regulator when you select Off. The generator will then stop generating an output voltage. |
| Starter Relay Control | Engine Output Controls/Starter Relay Control | The engine control module (ECM) grounds the starter relay control circuit when ON is selected. When Off is selected, ground is removed from the circuit. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.