Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 101 (HVAC SYSTEMS - AUTOMATIC)SPECIFICATIONSNOTES
2004 Oldsmobile Bravada AWD
Section 101 (HVAC Systems - Automatic): Specifications: Notes
2004 Oldsmobile Bravada AWDSECTION Notes
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
SYSTEM SPECIFICATIONS
| Application | Specification | ||||||||
|---|---|---|---|---|---|---|---|---|---|
| Compressor Type | Sanden Scroll | ||||||||
| Compressor Belt Tension | (1) | ||||||||
| System Oil Capacity (2) | |||||||||
| With Rear A/C | 8.5 ozs. | ||||||||
| Without Rear A/C | 7.4 ozs. | ||||||||
| Refrigerant (R-134a) Capacity | |||||||||
| With Rear A/C | 48 ozs. | ||||||||
| Without Rear A/C | 29 ozs. | ||||||||
| System Operating Pressures (3) | |||||||||
| High Side | |||||||||
| With Rear A/C | 161-213 psi (11.3-15.0 kg/cm2 ) | ||||||||
| Without Rear A/C | 160-200 psi (11.2-14.1 kg/cm2 ) | ||||||||
| Low Side | |||||||||
| With Rear A/C | 43-57 psi (3.0-4.0 kg/cm2 ) | ||||||||
| Without Rear A/C | 31-44 psi (2.2-3.1 kg/cm2 ) | ||||||||
|
|||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.