Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1000 (BATTERY, CHARGING SYSTEM & STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR REPLACEMENT (8.1L ENGINE)INSTALLATION PROCEDURE

2004 Oldsmobile Bravada AWD

Installation Procedure

2004 Oldsmobile Bravada AWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the generator.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the generator bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).

Fig 1: View Of Generator (8.1L)

Courtesy of GENERAL MOTORS CORP.

Install the drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 8.1L.
Install the generator cable to the generator, perform the following:
1. Install the generator cable.
2. Install the generator cable nut to the terminal.
  Tighten: Tighten the nut to 9 N.m (80 lb in).
3. Slide the boot over the terminal stud.

Fig 2: View Of Generator Cable & Nut

Courtesy of GENERAL MOTORS CORP.

Connect the generator electrical connector (1).

Fig 3: View Of Generator Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.