Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
    Fig 1: View Of Generator Electrical Connector
    GM898329Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  2. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory in Engine Mechanical - 4.8L, 5.3L, and 6.0L.
  3. Disconnect the generator electrical connector.
  4. Fig 2: View Of Generator Cable Boot, Head, Nut & Bolt
    GM899614Courtesy of GENERAL MOTORS CORP.
  5. Remove the generator cable (3) from the generator, perform the following:
    1. Slide the boot (1) down revealing the terminal stud.
    2. Remove the generator cable nut (2) from the terminal stud.
    3. Remove the generator cable (3).
  6. Fig 3: View Of Generator & Bolts
    GM899619Courtesy of GENERAL MOTORS CORP.
  7. Remove the generator bolts.
  8. Remove the generator.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.