Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the generator and secure the generator with 3 bolts.
Tighten: Tighten the generator bolts to 50 N.m (37 lb ft).
- Connect the battery positive cable to the generator and secure the positive cable with the nut (1).
Tighten: Tighten the generator positive cable nut to 9 N.m (80 lb in).
- Install the engine lift hook and secure the lift hook with 2 bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
- Install the A/C line bracket to the lift hook and secure the bracket with the bolt.
Tighten: Tighten the A/C line bracket bolt to 10 N.m (89 lb in).
- Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 4.2L.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.